Subgroups

Forums Forums SQ Forums SQ general discussions Subgroups

This topic contains 4 replies, has 5 voices, and was last updated by Profile photo of Andy Andy 6 years ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #68905
    Profile photo of Maxdrums
    Maxdrums
    Participant

    can you create sub-groups for example drums-guitars-voices to be processed separately and send them to the Main and keep the 12 stero mixes for example 12 aux?

    #68907
    Profile photo of Flo84
    Flo84
    Participant

    Hi,
    if you want full 12 mixes as AUX you can’t have Groups…
    But… If you don’t need to apply processes on sub-groups you can use DCA to control level for lot of channels in same time 😉

    #68908
    Profile photo of lightingman117
    lightingman117
    Participant

    sub-groups & aux are either/or 12 aux or 12 groups (or in between 1/11, 6/6, etc).

    There isn’t 12 auxes AND 12 groups.

    There are 3 Mtx

    #69383
    Profile photo of Patte
    Patte
    Participant

    He asked to process groups of channels at once. Not control the volume of a group of channels at once 😉

    #69435
    Profile photo of Andy
    Andy
    Participant

    I don’t own a desk, but I found this in the manual:

    In SETUP – MIXER CONFIG – BUS CONFIG you can set the number of groups and mixes. There are 12 stereo mixes and you can choose how many of them you want to use as subgroup instead of an aux mix. For example, you want to have 2 subgroups, than there are 10 aux mixes left. And you can select, if a mix or group is stereo or mono.

    https://www.allen-heath.com/media/SQ_ReferenceGuide_v1_0_1.pdf

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.