Qu-16 Levels when recording via USB interface

Forums › Forums › Qu Forums › Qu general discussions › Qu-16 Levels when recording via USB interface

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of Alex A&H Alex A&H 6 years, 2 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2018/02/08 at 3:52 pm #68756
    Profile photo of benniii
    benniii
    Participant

    me again 🙂
    i am wondering if it’s possible to control the pre-gains of an USB recordings (via the 24-channel interface) separately from the actual channels gain.
    quite often i am experiencing clipping in my DAW, eventhough the channels sound decently levelled on the main mix.

    2018/02/08 at 4:51 pm #68757
    Profile photo of Alex A&H
    Alex A&H
    Keymaster

    Hi Benniii,

    First I would suggest using the direct out for USB recording rather than the insert send. You can change this by going to Setup > IO Patch > USB Audio and pressing the CH/ST/Grp source so it says Direct Outs.

    Each channel has it’s own direct out trim. So select a channel you would like to attenuate, and then press the Routing key, you can trim the level here.

    Thanks!

    Alex

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.