GLD editor for dummies

Forums Forums GLD Forums GLD general discussions GLD editor for dummies

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Rick Rick 6 years, 9 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #63518
    Profile photo of Rick
    Rick
    Participant

    I am starting with setup of a yet to be purchased GLD-80. I don’t see a way to add an AR168 to the I/O.

    #63520
    Profile photo of Chris93
    Chris93
    Participant

    All possible audioracks are accounted for with what’s already there. In the I/O tab dSnake is whatever’s plugged into the dSnake port, up to 24/12, dSnake EXP is whatever’s plugged into the expander port of whatever’s plugged into the DSnake port, up to 16/8. It shows the maximum I/O that could exist, you just use as much of that as you have.

    If you’re plugging an AR168 into the dSnake port just use the first 16 in and 8 out on the dSnake tab.

    Chris

    #63700
    Profile photo of Rick
    Rick
    Participant

    Thanks for the reply. I am starting to understand some basics. One that I approached in the wrong way was assigning inputs to strips. I started by trying to name the strip and assign an input to the strip, wrong. Assign a name to an input and assign it to a strip. I claimed “for dummies”.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.