Direct monitoring – when record with Vst – guitar amp simplator

Forums Forums Qu Forums Qu DAW integration Direct monitoring – when record with Vst – guitar amp simplator

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of Giga Giga 6 years, 1 month ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #68605
    Profile photo of perri meracelli
    perri meracelli
    Participant

    HI. I need to have direct monitoring when I record into Cubase. This is when using a amp simulator, so that the latency is gone.

    This si simple a knob to push in some soundcard. But It has ato be poosible also in this board ?

    about diercet monitoring here : https://support.focusrite.com/hc/en-gb/articles/207546305-What-is-direct-monitoring-

    So , how do I set this up ? I have a superfast PC with i9 proseccor, but still this delay is makin it impoosible to record in time .

    #68611
    Profile photo of Giga
    Giga
    Participant

    Split your guitarsignal, one goes to a real amp, this becomes your “monitorsound”, record the other clean/direct signal in your DAW. Add ampsimulation later and if needed drag the track in time.

    Good luck !

    Giga

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.